Nortek V2IS 2 Way Vehicle Driver & Passenger Intercom System
With the increase in the number of protective screens fitted to vehicles such as Taxi’s and Buses to segregate the driver and passenger areas, so is the increase in the requirement for a 2-Way Vehicle Driver and Passenger intercom system to enable clear conversation to take place.
The V2IS is a dedicated Automotive Intercom System designed and manufactured in the UK. Its purpose is to provide clear, audio conversation between driver and passenger in a situation where they are separated by a perspex barrier – of which also provides a degree of screening against audio feedback.
The V2IS Driver – Passenger Intercom is designed to operate from a 10v – 30v DC Supply making it suitable for fitting into a wide range of vehicles in passenger carrying applications without the need or expense of additional DC-DC Converters and is directly suitable for Taxi Cab, Uber and Bus applications.
Although the V2IS Intercom has a strong established market for Automotive applications, with the addition of a suitable 12v – 24v power supply, it can also find its way into commercial applications, such as the counter screen of Post Offices, Banks, Petrol Stations and Toll booths.
Some of the Applications for the V2IS Automotive 2-Way Intercom System include
Vehicle Intercom System
Van Intercom System
Bus Intercom System
Coach Intercom System
Taxi Intercom System
Driver – Passenger Intercom System
Kiosk Intercom System
Counter Intercom System
Toll Booth Intercom System
The V2IS System, can be continuously powered, but has an additional control input which when connected to GND enables both the Driver and Passenger sections of the Intercom. This input can be connected to allow remote push to talk (PTT) switches controlled by each party, or alternatively can be activated by relays or control signals from elsewhere in the vehicle, such as automatically activating the intercom when the handbrake is applied. Connection is also available for an optional indicator “TALK” lamp(s) which give a visual indication of when the Mic circuits are active.
Our dedicated Push to talk switch, has the ‘TALK’ lamp built into the switch, in order to give each party clear indication that the microphone is active.
The Push-To-Talk Buttons, Speakers and Microphones are all available to buy as component parts for vehicle builders, or we can supply a pre-wired combined Microphone and PTT module for easy mounting into aftermarket applications.
V2IS Speaker and combined PTT & Mic Module for surface fitting, such as on a dividing partition screen.
An IP67 Rated PTT & Mic Module & Loudspeaker can be manufactured to special order for external applications, such as refuse collection vehicles.
Typical Installation Overview
A pair of gain controls are accessible from inside the Main Unit which allow additional adjustment to each Microphone channel to allow for different applications and vehicle layouts.
Power, Signal and Loudspeaker Connections are made to the V2IS using a 12 way TE Automotive connector. Microphone inputs use 3.5mm jack sockets. The Speaker outputs can drive either 8 ohm and 4 ohm speakers (4 ohm recommended for maximum output)
For more information on the V2IS Automotive Driver & Passenger intercom or to obtain a quote based on your requirements please use the enquiry form below.